Instruction of LED Wristbands DMX Transmitter
1.Power Connection
Plug in the circular connector and tight the ring.
2.Audio Mode
Press the button “X10” and hold for 2 seconds, then the TFT screen shows “Audio”, now the controller switchs to audio control mode. The same way switch to remote control mode.
At audio mode, the light colors still programmable.
Audio mode only works via DMX512 lighting console, the controller itself can not send audio signals individually.
Audio sensitivity:CH41 (0 stead ON, 1 flash , 2 high sensitivity===>255 low sensitivity).
3.Channel + – Switches
- Num -,Num + :decrease/increase 1 or 10 each time push the button.
- X10: Push the X10 button, the screen show “X10”, means it decrease / increase 10 each time.
- Push the X10 button again, the “X10” disappears on the screen,means now decrease / increase 1 each time.
- Push the button Num – & Num + at the same time, the CH NO. Will back to 0.
4.Signal Power Adjustment
Level 1-level 6 (low ===> strong)
Double click the button “X10” to increase or decrease the signal power.
5.DMX Datasheet
Note: The audio control is on 41CH.
Leave A Comment